Light Output |
|
0-6 Deg |
20mW/Sr min. @ 100% output |
6-11 Deg |
10mW/Sr min. @ 100% output |
11-20 Deg |
5mW/Sr min. @ 100% output |
Horizontal Output |
360° |
Output Modes |
100%,50% & high-intensity flash (60fpm) |
Expected Ranges with GEN-III NVG (200pW/m2 good vis.) |
0-6 Deg |
6.5nm detection, 3.3nm good visibility |
6-11 Deg |
5.5nm detection, 2.6nm good visibility |
11-20 Deg |
4.4nm detection, 2.0nm good visibility |
Operation |
Daily Operational Profile |
For 60 minutes once switched on during the day. Until dawn once switched on at night. |
Latitude Range |
55° S to 55° N |
Illumination Technology |
24 LEDs depending on color |
Life span of LEDs |
Up to 100,000 hours |
Color Output |
Infrared Light (870nm) |
On/Off Lux Level |
23 lux avg. / 85 lux avg.
Response to lux level change: app. 10 sec. |
FLASH MODE - On Time/Off Time |
0.25 sec / 0.75 sec |
Autonomy |
|
| ALC Disabled |
120 hrs @ full power (100% battery) |
| ALC Enabled |
270 hrs @ full power (100% battery) |
Solar Panels and Battery |
| Solar Panels |
Mono-Crystalline. Potted with UV-protected polyurethane |
| Battery |
Pure-lead thin plate with starved-electrolyte |
Environmental |
|
| Max. Temperature Range* |
-40° to +80° C
(-40° to 176° F) |
| |
| Waterproof |
As per IP67 (NEMA 6) |
Construction |
Lens Color |
Clear |
| Lens Material
|
UV-Resistant Poly carbonate |
Battery Venting |
One-way 4 psi vent at bottom of light |
Head Assembly Material |
Powder Coated Aluminum |
Housing Assembly Material |
Powder Coated Aluminum |
Sealingt |
Self-contained unit, sealed with NBR rubber gaskets |
| Weight |
7.75 kg (17 lbs) |
Patents and Trademarks |
Trademarks and Patents |
US Patents: 5,782,552 / 6,013,985 / 6,573,659
Canadian Patents: 2,241,044
U.S. Trademarks: 2,862,539
Accessories
| 50145 |
2" to 1" Frangible Coupling |
| The 2" to 1" frangible coupling includes a 1" column with additional set screw for secure installation using Chairman aviation accessories. The 2" to 1" frangible coupling adapts to the 1.5" Chairman Floor Flange, the 2" Chairman Floor Flange, the 601 airport mounting plate and conventional 2" threaded NPT stakes. The 2" to 1" frangible coupling is manufactured out of aluminum, providing FAA compliance for high and medium intensity edge light requirements.
The 2" NPT Frangible Coupling will provide a permanent, temporary or expedited mounting system for Carmanah aviation lights. |
|
| The 2.0" floor flange is designed for concrete installations using the 2" to 1" frangible coupling for taxiway, runway, threshold, apron, or helipad edge installations. The 2.0" floor flange is excellent for permanent installations where current infrastructure is not in place and edge lights need to be secured and frangible. |
|
| 37002 |
Airport Mounting Stake (1.5" Hub) |
| Manufactured out of galvanized steel, the all weather airport mounting stake allows for permanent installation in earth and gravel environments at general aviation airports and remote defense airfields. The 30" airport mounting stake is available in 2" and 1.5" coupling configurations. Frangible coupling size must be determined before ordering. Stake (Angle Iron) Mounting Instructions: Install the stake in a 6" (15 cm) diameter hole at a depth of 30" (76 cm). Do not install stake by driving it into the ground. Backfill around the stake with thoroughly compacted earth passing a 1" (2.54 cm) sieve. Where required due to unstable soil conditions, backfill with concrete. Install the top of the stake even with, or not more than 1/2" (1.3 cm), above the finished grade and maintain within 1 degree of the vertical. In areas where frost may cause heaving, anchor the stake with concrete and use a permeable backfill material such as sand and then cover the top surface with an impervious material to reduce moisture penetration. |
|
| 38964 |
Airport Mounting Stake (2" Hub) |
| Manufactured out of galvanized steel, the all weather airport mounting stake allows for permanent installation in earth and gravel environments at general aviation airports and remote defense airfields. The 30" airport mounting stake is available in 2" and 1.5" coupling configurations. Frangible coupling size must be determined before ordering. Stake (Angle Iron) Mounting Instructions: Install the stake in a 6" (15 cm) diameter hole at a depth of 30" (76 cm). Do not install stake by driving it into the ground. Backfill around the stake with thoroughly compacted earth passing a 1" (2.54 cm) sieve. Where required due to unstable soil conditions, backfill with concrete. Install the top of the stake even with, or not more than 1/2" (1.3 cm), above the finished grade and maintain within 1 degree of the vertical. In areas where frost may cause heaving, anchor the stake with concrete and use a permeable backfill material such as sand and then cover the top surface with an impervious material to reduce moisture penetration. |
|
| Optional infrared programmer. Functions available through the programmer include: Flash code settings Intensity and autonomy adjustments LUX Level adjustments for the photoelectric switch that automatically turns the on/off at dusk/dawn Activation / deactivation ability for storage or transport A battery voltage check to determine the relative health of the battery system About the infrared programmer The programmer employed by Carmanah to control its Model A601 and A702 aviation lights is a standard infrared unit, identical to those used to operate televisions, VCR's, stereos, etc. Why use a standard infrared programmer? There are many reasons behind this decision: Infrared technology requires minimal additional power to work effectively -- an important quality for our solar-powered, self-contained products. The programmer is simple to use and people are typically familiar with its operation. The programmer is extremely cost-effective. These programmers are mass-produced and the cost is very low relative to the cost of supplying a programmer custom manufactured by Carmanah. Operating the infrared programmer A video tutorial on the use of the Carmanah infrared programming is available here. |
|
| 36339 |
700 Series Mounting Plate |
| The Carmanah airport 700 Series mounting plate is designed for elevated runway, threshold and runway caution edge lighting. The 700 Series mounting plate is designed for stake mounted or floor flange installations on concrete and/or dirt surfaces. Manufactured to fit 1.5" or 2" to 1" frangible couplings, the 700 Series mounting plate is designed to bolt into the bottom of the 700 series aviation light using stainless steel bolts. Powder coated aviation yellow, the 700 Series mounting plate adapts to the 1.5" Carmanah Floor Flange using a 1.5" frangible coupling or the 2" Carmanah Floor Flange using a 2" to 1" frangible coupling. Common size of the airports coupling will determine which floor flange is ordered. |
|
| 38339 |
700 Series Mounting Bolt Kit |
| The 700 Series Bolt Kit contains the required hardware to mount 700 series lights to the correct mounting bases. Each package contains the necessary items to properly mount one light. Parts list includes: Flat washer, ½", SS (8) Screw, cap, hex, ½"-13, SS (4) Nut, lock, ½"-13, SS (4) |
|
| 46397 |
Wedge Anchor Bolt Kit |
| The Carmanah airport wedge anchor bolt is designed for securing the 1.5" or 2" Floor Flange to hardened concrete and dirt surfaces. Four 3/8" X 3 ¾" wedge anchor bolts are used in installations on permanent, temporary and expedited airfields. Combined with the 1.5" or 2" Floor Flange, these wedge anchor bolts are ideal for permanent installations where current infrastructure is not in place and edge lights need to be secured and frangible. |
|
| The A702 IR Shield is used for Defense "box and one" operations providing unidirectional 180 degree infrared or visible output. The unit can be installed by the end user or during manufacturing offering versatile performance in the rare chance that omnidirectional output may be needed at a later date. |
|
| The Carmanah bird deterrent accessory attaches easily to any Model 601 or 700 Series light. The spikes on the deterrent discourage birds from perching on the light. |
|
|
|
|
To discuss
