The 2.0" floor flange is designed for concrete installations using the 2" to 1" frangible coupling for taxiway, runway, threshold, apron, or helipad edge installations. The 2.0" floor flange is excellent for permanent installations where current infrastructure is not in place and edge lights need to be secured and frangible.

Manufactured out of galvanized steel, the all weather airport mounting stake allows for permanent installation in earth and gravel environments at general aviation airports and remote defense airfields. The 30" airport mounting stake is available in 2" and 1.5" coupling configurations. Frangible coupling size must be determined before ordering. Stake (Angle Iron) Mounting Instructions: Install the stake in a 6" (15 cm) diameter hole at a depth of 30" (76 cm). Do not install stake by driving it into the ground. Backfill around the stake with thoroughly compacted earth passing a 1" (2.54 cm) sieve. Where required due to unstable soil conditions, backfill with concrete. Install the top of the stake even with, or not more than 1/2" (1.3 cm), above the finished grade and maintain within 1 degree of the vertical. In areas where frost may cause heaving, anchor the stake with concrete and use a permeable backfill material such as sand and then cover the top surface with an impervious material to reduce moisture penetration.

Manufactured out of galvanized steel, the all weather airport mounting stake allows for permanent installation in earth and gravel environments at general aviation airports and remote defense airfields. The 30" airport mounting stake is available in 2" and 1.5" coupling configurations. Frangible coupling size must be determined before ordering. Stake (Angle Iron) Mounting Instructions: Install the stake in a 6" (15 cm) diameter hole at a depth of 30" (76 cm). Do not install stake by driving it into the ground. Backfill around the stake with thoroughly compacted earth passing a 1" (2.54 cm) sieve. Where required due to unstable soil conditions, backfill with concrete. Install the top of the stake even with, or not more than 1/2" (1.3 cm), above the finished grade and maintain within 1 degree of the vertical. In areas where frost may cause heaving, anchor the stake with concrete and use a permeable backfill material such as sand and then cover the top surface with an impervious material to reduce moisture penetration.

Optional infrared programmer. Functions available through the programmer include: Flash code settings Intensity and autonomy adjustments LUX Level adjustments for the photoelectric switch that automatically turns the on/off at dusk/dawn Activation / deactivation ability for storage or transport A battery voltage check to determine the relative health of the battery system About the infrared programmer The programmer to control its Model A601 and A702 aviation lights is a standard infrared unit, identical to those used to operate televisions, VCR's, stereos, etc. Why use a standard infrared programmer? There are many reasons behind this decision: Infrared technology requires minimal additional power to work effectively -- an important quality for our solar-powered, self-contained products. The programmer is simple to use and people are typically familiar with its operation. The programmer is extremely cost-effective. These programmers are mass-produced and the cost is very low relative to the cost of supplying a programmer Operating the infrared programmer.

The airport 700 Series mounting plate is designed for elevated runway, threshold and runway caution edge lighting. The 700 Series mounting plate is designed for stake mounted or floor flange installations on concrete and/or dirt surfaces. Manufactured to fit 1.5" or 2" to 1" frangible couplings, the 700 Series mounting plate is designed to bolt into the bottom of the 700 series aviation light using stainless steel bolts. Powder coated aviation yellow, the 700 Series mounting plate adapts to the 1.5" Floor Flange using a 1.5" frangible coupling or the 2" Floor Flange using a 2" to 1" frangible coupling. Common size of the airports coupling will determine which floor flange is ordered.

The bird deterrent accessory attaches easily to any Model 601 or 700 Series light. The spikes on the deterrent discourage birds from perching on the light.